Procedures in Maintaining a Swimming Pool Water Balance

A balanced swimming pool must always be attained and this means maintaining water balance, and that's why it is important first to know the reasons why a water balance is required for maintaining a safe pool. To learn more about  pools lexington sc  , follow the link.

A good water balance in a swimming pool must have a pH reading that falls in the range of 7.4 to 7.6 to attain a safe water condition where there are no presences of germs and bacteria; therefore, if your pool is either using a salt-based pool producing chlorine or a chlorine-based tablet pool, then the pH of the water needs to be corrected for the chlorine sanitizer to function effectively. The pH refers to the acidity or alkalinity level of the pool water, such that a reading of 0 to 7.0 reflects an acidic water level and a pH reading from 8.0 to 14.0 means the pool water is basic or alkaline. A good water balance in a swimming pool must have a pH reading of 7.4 to 7.6, which is slightly alkaline or slightly neutral.

When the pH level of the pool water is not maintained, the effect could result into an unsafe pool and unbalanced pool water, such that low pH reading (below 7.4) allows for chlorine to dissolve quicker, which means the pool water when maintained with chlorine or bleach will make the water more acidic, causing skin and eye irritation, and corrode the pool liner, ladders, hand rail and pump, while a high ph reading (above 7.6) males the pool water to be more alkaline, which makes the chlorine or bleach used for disinfecting pool ineffective, which results into bacterial and germ presence in the pool, as well as introducing corrosion to the pool accessories. Aside from the pH reading, another way to measure the right water balance in a pool is to use a device that measures the alkalinity reading of 100 ppm (parts per million), which is the ideal alkaline condition in a pool. The best information about   pool repair lexington sc  is available when you click the link.

Part of a good water balance is also determining the ideal amount of calcium in the water, which is 300 ppm, because if the calcium reading is below 300 ppm, this means there is less calcium and this can cause erosion of the pool plaster, while too much calcium, above 300 ppm, could make the pool water cloudy such that scaling and stains may build up.

It is important to use a stabilizer to make the chlorine stay longer just enough to make disinfection work, since chlorine or bleach is normally used to disinfect the pool.

There is need to either drain some water or add fresh water in the pool, since all water contains dissolved minerals that remain in the pool and become concentrated when the water evaporates, and when this happens, it is hard for chemical additives, that are applied to the pool for maintenance, become effective.